2021 SCAG Power Equipment SFC30 SFC30

Features may include:

FULLY FABRICATED AND WELDED STEEL CUTTER DECK

MILITARY-GRADE STEEL - DECK

Extra-strong fabricated (non-stamped) steel cutter deck features 14-gauge, grade 100 Military-Grade steel deck shell, 12-gauge spindle reinforcement plate and side reinforcement bar, all while delivering the quality-of-cut youd expect from a Scag mower.

FULLY FABRICATED AND WELDED STEEL FRAME

MILITARY-GRADE STEEL - FRAME

Extra-strong, fully fabricated steel frame (not cast aluminum). The Military-Grade steel spec used on the SFC30 is over 200% stronger than standard drawing steel found in common stamped frames and decks in this machine class.

SINGLE POINT HEIGHT-OF-CUT ADJUSTMENT

FINE-TUNED AND SIMPLE

Adjust the height-of-cut from a single location rather than at all four corners or having to adjust the front and back tires separately. Refine your height settings with adjustments from 1.5 to 5 in .25 increments.

OFFSET BLADE SET UP

SIMPLIFIED DECK DRIVE SYSTEM

An offset blade design is less complex and easier to maintain than traditional timed deck setups. This more robust system results in potential belt replacements taking less than half the amount of time to repair/replace compared to timed deck systems. Image shown with bagging baffle.

SCAG LEVEL QUALITY-OF-CUT

UNMATCHED PERFORMANCE

The large cutting chamber helps process more grass while being able to eat through wet and lush spring time grasses more efficiently. Cutter deck discharge opening is oversized for its class.

OPERATOR CONTROL PANEL

ERGONOMIC CONTROLS

Angles of operator station controls match the natural angles of your outstretched hands. All controls are within easy reach: blade brake engagement, drive engagement, recoil start, throttle/choke, hour meter and park brake.

Fuel Capacity:
1 gallon
Length:
Transport (handles in upright transport position): 41" | Minimum (handles in highest operating position): 66" | Max (handles in lowest operating position): 73.5"
Weight, in running order:
Operating Weight - Bagging: 220 lbs. | Operating Weight - Mulching: 214 lbs. | Operating Weight - Discharging: 213 lbs.

Cutting Width:
30"
Parking Brake:
Hand lever
Width:
Tracking: 28.75" | (w/ discharge chute): 36.75" | (w/ discharge block off plate): 31.5"
Features:
Bag Capacity: 2.5 Bushels
Operating Speed:
Forward Ground Speed: Up to 4 mph
Height:
Lowest Operating: 36.75" | Max Operating: 45.25" | w/ Handle Bar in Storage Position: 57.5" | Cutting: 1.5" to 5" in .25" increments.
Drive system:
GT MV 702 Transmission
Construction Material, Deck:
Type: Extra-strong, fully fabricated and welded steel cutter deck. Offset blade, non-timed deck setup. | 14-gauge, grade 100, Military Grade steel deck shell with 12-gauge spindle reinforcement plate. �� trim side reinforcement bar offers extra protection against impacts.
Spindle Type:
Aluminum housing with sealed ball bearings.
Tires, Front Specification:
9� x 2.25� rubber tire w/ glass-filled polypropylene wheel
Tires, Rear Specification:
10.5" x 3" rubber tire w/ glass-filled polypropylene wheel